Power & Motoryacht Boat Test The Back Cove 41

Back Cove 41

Photography By Billy Black

Pure Joy

The practical Back Cove 41 appears to be a traditional Down Easter, but technology and construction set her apart.

I was feeling the way I always do when a boathandling jackpot’s bearing down. The feeling’s a little paradoxical really, part pins-and-needles, part sporty anticipation. Not that there was much current to worry about—the tide was flooding Marker 1 Marina, in Dunedin, Florida, and we were close to high-water slack by the looks of the nearby seawalls. And the wind was no biggie either—it was light, just a ruffle now and then.

But the slip I was headed for? The darn thing was squeezed into a crowded little corner, with a gelcoat-eating concrete pier on one side, a prickly ol’ sportfisherman on the other, and a fairway out in front that was, due to a miasma of bow pulpits and swim platforms, not even remotely wide enough to pivot our brand-new Back Cove 41 freely for a proper backdown. Indeed, the slip was such a bear that earlier that morning, just as we were about to depart for a sea trial in nearby St. Joseph Sound, Back Cove skipper Dave Weaver had advised: “Better let me take her out of here, Bill—dealing with a slip like this is bad news—lotta potential for screw ups.”

But now Weaver’d changed his take on things apparently. As I eased our test boat back through the marina, with the sea trial on the sound over and done with, he was making nary a move to get behind the wheel again, most likely because he’d seen just how deeply the boat and I had bonded over the past couple of hours. “Go ahead and put her in the slip,” he suggested. “You got it.”

Bonding with the 41 had been easy. For starters, the boat had lots of oomph, thanks to a single 600-horsepower Cummins QSC8.3 diesel turning a big, 28-inch wheel through a deep, torque-boosting 2.39:1 gear ratio. On a virtually flat stretch of the sound, I’d measured a top hop of 27 knots and—even more significant for long-distance cruisers—a super-economical 1.5-gph fuel burn at a displacement-type speed of 7.5 knots.

The driving experience had been cool, too. Running attitudes were optimum throughout the rpm register, rising steadily from zip to 4 degrees at wide-open throttle. Turns were broad (as is typical of a single-engine powerboat), with an average tactical diameter of about four boat lengths. And the control interface was smooth and unencumbered. All I had to do was switch the optional Lenco automatic trim tabs on and I could drive with free-form simplicity, using just the wheel and the throttle.

Then finally, the 41’s close-quarters handling characteristics had seemed pretty straightforward and confidence-inspiring as well, based on the half hour I’d spent maneuvering her on the edge of the sound, using a channel marker as a reference. Like any other single-engine vessel with a left-hand-turning wheel, she’d backed to starboard in slow-mo mode, swung to port through 360 degrees with just a couple of forward-reverse gear changeups, and taken a few  more changeups when swinging in the opposite direction, an issue her two standard-issue, Side-Power proportional thrusters, one forward and the other aft, had dealt with quite handily.

“I’ll keep an eye on the stern for you,” said Weaver, as I stopped the 41 a good ways short of our slip and began a slow turn to port, so I could sneak the boat’s nose into a vacant spot between two bow pulpits on the far side and start sidling sideways. With full left rudder, I juiced the throttle ahead for just a second to energize the rotation I’d started and then, after pulling the stick back and centering the rudder, applied a perfect whiff of stern-thruster action.

“Whoa,” I commented, enjoying the precision of it all, “this is lovely.”

Getting the transom lined up with the mouth of the slip was tricky and, at one point, I had to walk the boat sideways several feet with the thrusters, while simultaneously inching either forward or astern with the main engine to stay clear of various obstructions. But man oh man—when I eventually got the 41 safely parked in that dicey little slip, without having brushed a piling, swim platform, or bow pulpit even slightly, I experienced a serious shot of gratitude. And what’s more, I experienced a serious shot of admiration, too—the 41’s simple, thruster-augmented powerplant had performed spectacularly, with none of the roar, turbulence, and clumsy drama that pod-type propulsion systems often generate. Cool!

The tour of the 41 that followed was instructive. In the engine room, accessed via a guttered (and drained) cockpit hatch, I gladly encountered two sets of see-through, cross-linked poly fuel and water tanks. Sure, modern electronic or even mechanical fuel gauges work pretty well. But sighting a tank’s levels by eye is fail-safe reliable. Some other features I was glad to see included a bonding system comprised of #6 wire instead of the smaller #8 wire you commonly encounter, even on larger vessels; a giant, easy-to-understand fuel manifolding system; and, of course, oodles of elbow room, a trait that most, but certainly not all, single-engine powerboats share.

I ran into one engineering detail I didn’t much care for, though—access to the raw-water strainer for the genset (in a lazarette space immediately abaft the ER and accessed through a second cockpit hatch) was, to say the least, limited. “They need to move it out from behind the genset,” I told Weaver, “to a spot where it’s easier to clean and maintain.” He agreed, rather heartily I thought.

Aspects of construction I noted while checking out the ER were indicative of modern, highly sophisticated boatbuilding methods. Both the hull and the foam-cored longitudinals and athwartship members inside it, for example, had been simultaneously resin-infused in one shot—there was no secondary bonding. In addition, Corecell had been used to further boost panel strength, thereby making the hull’s bottom rock solid; Coosa board had been substituted for Corecell in way of all through-hull fittings to nix compression; and Weaver said a vinylester-impregnated skin coat had been applied to prevent print-through as well as osmotic blistering.

I was totally down with the practicality and elegance of the 41’s interior. Up forward and to starboard on the main deck, I found a set of cushy Stidd helmchairs, each mounted atop a stout fiberglass molding with a good bit of stowage (as well as an air-conditioning unit with plenum) inside. In addtion, there was a small, L-shaped lounge opposite to port, an ample, U-shaped dinette farther aft to starboard and, just across the way, a long, chef-worthy galley with a cooktop, under-counter refrigerator, and a microwave oven, all nicely ensconced in some finely crafted, made-in-the-U.S.A. cabinetry. A feature I especially liked here was the door to starboard of the two Stidd seats—nothing facilitates docking a boat (or casting off, for that matter) like easy travels between helm station and side deck. And one more feature I especially liked—virtually everything I was looking at was standard. The 41’s got very, very few options.

Only a couple of steps took Weaver and I down to the accommodation space where there was an island-queen-equipped master all the way forward, with a shower-stall-accoutered head adjoining on the starboard side. Across the hallway, to port, was a somewhat less ample dayhead which also serves the guest stateroom, a comparatively large and luxurious space with a double bunk (running athwartship beneath the saloon sole), plenty of standing headroom, an opening port, hanging locker, a couple of drawers, and more fine made-in-the-U.S.A. cabinetry.

“Nice warm, bright interior,” I concluded, as we finished up, “but what really floats my boat is this baby’s dockside handling—I mean, with those two proportional thrusters and that big wheel she’s as maneuverable—maybe even more maneuverable—than a podster. And, by comparison, she’s gonna be both simpler mechanically and cheaper to buy and maintain.”

“Yup,” he replied, with a grin, “That’s just about it in a nutshell.”

Back Cove 41.

 

http://www.bluewateryachtsales.com/new-models/163/

Contact Hank Sibley for more Information:

Hank Sibley
hsibley@bluewateryachtsales.com
Sales Professional
Hampton, VA
804.337.1945 (Mobile)
757.723.0793 x305 (Office)
757.723.3329 (Fax)

Advertisements

Author: Bluewater Yacht Sales

Hank Sibley hsibley@bluewateryachtsales.com Sales Professional Bluewater Yacht Sales Hampton, VA 804.337.1945 (Mobile) 757.788.7082 (Office) 757.723.3329 (Fax)

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s